Home > Products >

HTA 90/22 Aluminum Barrel Shroud For Factory 10/22 Barrels
HTA 90/22 Aluminum Barrel Shroud For Factory 10/22 Barrels

Alternative Views:

Price: $49.99

Stock Status:In Stock
Product Code: HTABSWA

Sometimes polymer just isn't good enough, especially if you're a die-hard shooter. It is for these purists in the shooting community that we developed an aluminum alternative to our 90/22 polymer barrel shroud. This shroud features rugged, black hardcoat anodize aluminum construction and is designed to fit the factory 10/22 tapered 18 1/2" barrel when installed in our bullpup rifle stock. This is accomplished with an included Melonite treated thread adapter which locks onto the muzzle of the factory barrel with two set screws and provides the necessary threads for attaching the aluminum shroud. Made in the USA and backed by HTA's lifetime warranty.

Note: This product requires the factory front post sight be removed prior to installation.

Warning: The included adapter may be illegal in some jurisdictions by creating a threaded attachment point for muzzle devices. Know your local laws.

Warning: Do not attempt to use the included adapter with a baffled muzzle device such as a muzzle break or suppressor as this could result in a bullet strike on the device.
  • Fits tapered factory 10/22 barrel
    Hardcoat anodized
    Aluminum single piece construction
    Melonite treated thread adapter
    1/2-28 threads
    Mounting hardware and wrench included
    Weight: 10 oz

High Tower Armory 90/22™ (Hydro-Dip) High Tower Armory 90/22™ (Desert Tan) High Tower Armory 90/22™ (OD Green) High Tower Armory 90/22™ (Flat Dark Earth)
Price: $349.99

Price: $269.99

Price: $269.99

Price: $269.99

High Tower Armory 90/22â„¢ (Hydro-Dip) High Tower Armory 90/22â„¢ (Desert Tan) High Tower Armory 90/22â„¢ (OD Green) High Tower Armory 90/22â„¢ (Flat Dark Earth)
High Tower Armory 90/22™ (Black)
Price: $269.99

High Tower Armory 90/22â„¢ (Black)

Average Rating: Average Rating: 5 of 5 5 of 5 Total Reviews: 1 Write a review »

  2 of 2 people found the following review helpful:
5 of 5 Do it! September 6, 2016
Reviewer: Daniel Lutz from GOOSE CREEK, SC United States  
the fake suppressor that comes standard makes the whole stock just feel/look off (too big and plastic) just go with out it...


It makes the whole setup! its smaller in diameter and securely attached. it makes for a very realistic appearance. just make sure the set screws are tightened enough to clear the side of the adapter, really small clearances and it will catch if you don't have it all the way in.

Was this review helpful to you?